Blomberg DWS 54100 FBI Installation Manual

Installation ManualDishwasherFOR MODELS (ADA Height)DWS 54100 SSDWS 54100 FBIUSA

7USA6.3.1 INSTALLING THE FOOT SUPPORTSSupplied (4)If the height of the enclosure is 337/16” to 341/4” (850mm - 870mm) use short supports as shown in t

8USAAdjust the front foot level with the adjusting wrench to balance and raise the dishwasher to the enclosure height.Adjust the rear foot level wi

9USA6.4 PREPARING THE WATER CONNECTION (A)Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder connections

10USA6.5 DRAIN PREPARATIONThe dishwasher drain hose may be connected to the drain plumbing in one of three ways (Figure A, B, C). Notice :• Either on

11USA6.7 STEAM PROTECTION FOILSteam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it

12USA7. PLACEMENT OF DISHWASHER INTO THE OPENINGNow place the dishwasher into the opening and get ready to connect all hoses and electrical connection

13USA7.1.2 WATER SUPPLY CONNECTIONWater supply may be connected to the dishwasher in one of two ways:• With metal braided hose.• With copper tubing.

14USA7.3 READJUSTING FOOT LEVELSNow that the dishwasher is in the cabinet you must readjust the feet to bring the dishw

15USALock the toe kick brackets as shown with the plastic tab in the figure C by pushing the plastic tab on the dishwasher into th

16USA 7.5 INSTALLING THE OUTER DOOR(DWS 54100 FBI)Measure the height and width of the enclosure

Installation Manual For Dishwasher ModelsDWS 54100 SSDWS 54100 FBI

17USA5. Attach the two mounting brackets to the wooden door with 4 screws (Ø 1/8” x 5/8” (Ø 3.5mm x 14mm) (Figure A).6. Mount the w

18USA7. Open the door and remove the two caps and two screws inside the door at position 1 and 3 (Figure C).8. Usi

19USA11. Check whether the bottom of the door hits the toe kick of the kitchen cabinet (A).11.1. If the door hits the toe kick cut the necessar

20USA Notice :If you have a European kitchen or want to install a wooden toe kick to match

21USA8. INSTALLER CHECKLISTYour installer must have completed and checked the following:• The dishwasher is square and level.• The dishwasher is fas

17 9872 01 00-AA-USA

1. IMPORTANT SAFETY INSTRUCTIONS 11.1 INSPECT THE DISHWASHER 21.2 HOW TO CONTACT US : 22. TOOLS WHICH MAY BE NEEDED 33. MATERIALS WHICH MAY BE NEE

1USAINTRODUCTIONPlease read this installation manual and particularly the safety instructions completely and carefully. They will

2USA• Dishwasher must be secured to adjacent cabinetry using the brackets provided. Failure to do this may cause damage to property or bodily injury.

3USA2. TOOLS WHICH MAY BE NEEDED3. MATERIALS WHICH MAY BE NEEDED(Additional materials may be required to comply with local codes)Hot Water Supply Line

4USA4. MATERIALS SUPPLIED4.1 PARTS SUPPLIEDParts for your dis

5USA5. DISHWASHER SPECIFICATIONS5.1 TECHNICAL FEATURESLoad capacity 8 place settingsPermissible water pressure4.35 - 145 psi (0.3 - 10 bars) Electrica

6USA6. ENCLOSURE PREPARATION6.1 ELECTRICAL PREPARATION WARNINGThe dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a