Blomberg DWT55100SS Quick Start Guide download pdf (Page 12)

USA

6.6 DRAIN PREPARATION

The dishwasher drain hose may be connected to the drain plumbing in one of three ways

(Figure A, B, C).

Notice :

Either one of the above methods must be used or the dishwasher will not operate 

properly.

A hose that attaches to a sink spray can burst if it is installed on the same water line as 

the dishwasher. If your sink has one, it is recommended that the hose be disconnected

and the hole plugged.

The total length of the drain hose is 76

” (1950mm). If a hose extension is required, a

drainage hose of equal quality must be used.

The maximum length must not exceed 157 ½” (4000mm). Otherwise, the cleaning 

process is negatively influenced.

6.6.1 UNDER THE SINK DRAIN

Install a Y-branch tail pipe. (Figure A)

Notice :

You must add a loop at least 28” (710mm) above the floor of 

the cabinet and above the drain connection in the drain hose

to prevent waste water from not draining properly, and causing

either poor washing results or a bad odor.

6.6.2 INSTALLING AN AIR GAP

If the local ordinance requires an air gap (Figure B).

Notice :

Check with local ordinance for type of air gap required.

6.6.3 DISPOSAL

Remove the drain connection plug before attaching the drain

hose from the dishwasher.

Every disposal has a hook up for a dishwasher; consult your

disposer manual for correct connection. (Figure C)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

No comments

Blomberg DWT55100SS Quick Start Guide Page 12