Blomberg TKF 1350 Operations Instructions download pdf (Page 6)

65

Installation

Proper location

For drying the appliance requires a

sufﬁcient supply of fresh air.

Install the dryer therefore in well-

ventilated, if possible, low-dust

rooms only. The vent slots of the

dryer must not be blocked nor

covered.

The appliance must not be installed

in rooms at risk of frost. Some parts

of the appliance contain water and

can be damaged in the case of frost.

Ensure that the ﬂoor has a sufﬁcient

load bearing capacity.

If a dryer is placed on top of a

washing machine, both appliances

together can weigh up to 150 kg

while loaded.

Important Advice

Place the appliance on an even and

level ﬂoor only.

Keep a distance of at least 1 cm to

walls and other furniture.

Washer/dryer combination

This dryer can be put on top of any

of our washing machines.

A special stacking kit is required

(Stock No. MBS 2000), available at

the customer service or specialized

trade.

Leveling

Adjust feet until the appliance

stands horizontally and ﬁrmly. Con-

trol with a water level.

Important advice:

Adjust by the feet only, do not use

wooden wedges or similar.

Do not remove the feet!

Changing hinge position

It is possible to change the hinge

position if it does not correspond to

local conditions.

If you wish to open the door to the

other side, you can have the hinge

position changed from left hand to

right and or vice versa by our cus-

tomer service.

Drain hose connection

The water (condense water) accumulated

during the drying process is caught in the

water tank, which you have to empty after

every drying.

You can also drain the water continuously

through the included drain hose by con-

necting it to a spout or other water drain-

age.

In that case you do not need to empty the

water tank after every drying cycle. The in-

dicator “Empty water tank” will nonetheless

ﬂash at the end of every program.

Important Advice

The length of the hose and the highest

point over the ﬂoor have to be taken into

consideration for the draining of the water.

Install the hose without kinks!

Install as follows:

1. At the water drain connection, pull up the

condensate hose out of the appliance by

hand. Do not use pliers!

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments