Blomberg GSN 9122 User Manual download pdf (Page 31)

Lime traces remain on dishes and glassware gains a misty appearance

• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse

aid if necessary. Increase the rinse aid setting if there is enough amount of

rinse aid in the machine.

• Water hardness setting is low or salt level is insufficient >>> Measure the

hardness of the supply water appropriately and check the water hardness

setting.

• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling

hole while adding salt. Make sure that the salt reservoir lid is tightly closed

after finishing the filling process. Run the prewash programme to remove the

salt that spilled inside the machine. Since the salt granules that will remain

under the lid will dissolve during prewash, causing the lid loosen, check the

lid once again at the end of the programme.

There is a different odour in the machine

C A new machine has a peculiar odour. It will fade out after a couple of

washing.

• Filters are clogged. >>> Check if the filter system is clean. Clean the filter

system regularly as illustrated in section "Cleaning and Care".

• Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going

to start the machine right after you have put the dishes into it, remove

the remnants on the dishes and run the Prewash programme without

detergent every 2 days. In such cases, do not close the door of the machine

completely in order to avoid odour build up in machine. You can also use

commercially available odour removers or machine cleaners.

1 2 ... 26 27 28 29 30 31 32 33 34 35

No comments

Blomberg GSN 9122 User Manual Page 31