Blomberg GVS 9480 XB20 User Manual download pdf (Page 8)

7

EN

3

Installation

Refer to the nearest Authorised

Service Agent for installation of your

product. To make the product ready

for use, make sure that the electricity,

tap water supply and water drainage

systems are appropriate before calling

the Authorised Service Agent. If they

are not, call a qualified technician

and plumber to have any necessary

arrangements carried out.

C Preparation of the location and

electrical, tap water and waste

water installations at the place of

installation is under customer's

responsibility.

B Installation and electrical

connections must be carried out

by the Authorised Service Agent.

Manufacturer shall not be held

liable for damages that may arise

from procedures carried out by

unauthorised persons.

B Prior to installation, visually check

if the product has any defects on

it. If so, do not have it installed.

Damaged products cause risks for

your safety.

A Make sure that the water inlet and

discharge hoses are not folded,

pinched or crushed while pushing

the product into its place after

installation or cleaning procedures.

When placing the product, pay

attention not to damage the floor,

walls, piping, etc. Do not hold the

product from its door or panel to

move it.

Appropriate installation

location

 Place the product on a solid and

flat floor that has sufficient load

carrying capacity! The product

must be installed on a flat surface

in order for the door to be closed

comfortably and securely.

 Do not install the product at places

where temperature may fall below

0ºC.

 Place the product at least 1 cm

away from the edges of other

furniture.

 Place the product on a rigid floor.

Do not place it on a long pile rug or

similar surfaces.

B Do not place the product on the

power cable.

 Make sure that you select a

location that will allow you to load

and unload the dishes in a fast and

comfortable manner.

 Install the product in a place close

to the tap and the drain hole.

Select the installation location

by considering that it will not be

changed after the connections are

made.

Connecting water supply

C We recommend attaching a filter

on the house/apartment supply

water inlet to protect the machine

from damages that may arise

from impurities (sand, dirt, rust,

etc.) coming from the urban water

supply system or from your own

water system as well as to prevent

complaints such as yellowing or

sludge accumulation at the end of

washing.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Comments to this Manuals

No comments