Blomberg GSN 9120 Instruction Manual download pdf (Page 17)

18

GB

After you put in the detergent, shut the

container lid (D) and ensure you hear

the clicking sound.

During the wash programme the

detergent will dispense automatically

and the lid (D) will remain open when

the programme finishes.

Do not use detergent when using the

pre-wash programme.

Rinse aid

Use only rinse aid intended for

household dishwashers.

The rinse aid is specially formulated

to be used in the dishwashers for the

prevention of watermarks and scale on

dishes and to increase the efficiency

of the washing and drying processes.

Therefore, make sure that there is

adequate amount of rinse aid in the

rinse aid dispenser of your machine.

You can adjust the amount of rinse

aid used during the wash programme

by turning the rinse aid dispenser

regulator (C).

The dispenser regulator (C) may be set

between levels 1 and 6 (6 being the

maximum amount of rinse aid usage).

Your machine is pre-set at the factory

to level 4.

According to the finish and drying

results obtained, adjust the dose of

rinse aid by means of the six position

selector. (Position 1: minimum dose,

Position 6: maximum dose.) Gradually

increase the dose if there are drops of

water or lime spots on the dishes after

washing. Reduce it if there are sticky

whitish streaks on the dishes.

Filling the rinse aid dispenser

Open the rinse aid dispenser lid by

pressing the button as shown in the

diagram.

Fill up with rinse aid until the container

is full to level of ’max’ mark .

Put the lid (E) on and ensure you hear

the clicking sound.

Remember to CLOSE the lid after

every refill.

Make sure you clean any rinse aid that

you might have spilled.







1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments