Blomberg DW25502SS Installation Manual download pdf (Page 18)

USA









































Lock the toe kick brackets as shown with the plastic

tab in the figure C by pushing the plastic tab on the

dishwasher into the teeth of the bracket (C).

3. Now attach the toe kick to the bracket with the

two (Ø

” x

” - Ø 4mm x 6mm) screws and

the caps provided as follows.

If the enclosure height is below 33

” (840mm)

use only “o” labelled toe kick (toe kick without slots).

Installation should be done following the steps

illustrated in the Figures A, B and C respectively.

1. Bend tabs on toe kick (o) inwards (A).

2. Secure toe kick to brackets with screws (t) as

shown in the supply bags (B).

3. Attach caps (s) as shown in the supply bags (C).

If the enclosure height is above 33

” (840mm)

use “o” and “p” labelled toe kicks together. Make

sure the slotted toe kick “p” is on the outside so you

can adjust height of the toe kick. Installation should

be done following the steps illustrated in the figures

A, B and C respectively.

1. Align the toe kick (o) and (p) (A).

2. Secure toe kicks to brackets with screws (t) after

adjusting the height of the slotted toe kick (p) (B).

3. Attach caps (s) as shown in the supply bags (C).

If the enclosure height is above 34

” (870mm) use

“o” and “r” labelled toe kicks together. Make sure

the slotted toe kick “r” is on the outside so you can

adjust height of the toe kick. Installation should be

done following the steps illustrated in the figures A,

B and C respectively.

1. Align the toe kick (o) and (r) (A).

2. Secure toe kicks to brackets with screws (r) after

adjusting the height of the slotted toe kick (t) (B).

3. Attach caps (s) as shown in the supply bags (C).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Blomberg DW25502SS Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Dishwashers Blomberg DW25502SS